Size*: 2.1 H x 3.6 W 3mm thick
SVG Blank Template available to download at time of purchase
Material: MDF for Sublimation- Double-sided
Remove clear protective film.
Clean with soft cloth and alcohol paying special attention to the edges where the film residue is likely to stick.
Place sub transfer paper design face down onto the blank
Secure with heat tape
For best results Press with paper facing up- don't forget your cover sheet.
**Press normally at 380 degrees for 50 seconds
Immediately remove paper
Repeat for the 2nd side
* sizes are approximate
** Material is to be used with a heat press. Time, Temp and pressure may vary depending upon your heat press.